11 Dismounting
11 Dismounting
EN - 20
Dismounting may only be carried out by specialized personnel. Please make
sure that the shutdown procedures are strictly observed, before the dismounting
work begins. Ensure this also for the components integrated into the welding
system.
DANGER
Risk of injury due to unexpected start-up
The following instructions must be adhered to for the entire duration of
maintenance, servicing, mounting, dismounting and repair work:
• Switch off the power source.
• Close the gas supply.
• Close off the compressed air supply.
• Disconnect all electrical connections.
• Switch off the entire welding system.
NOTE
• Observe the information provided in the following section:
8 Putting out of operation on page EN-17.
1 Disconnect the TIG welding torches from the power supply.
®
ABITIG
WH