Abicor Binzel TIG ABITIG WH Mode D'emploi page 31

®
ABITIG WH
6.1.1 Equipping TIG welding torches 200WS and 400WS
6.2 Tungsten electrode
6.3 Connecting the TIG welding torch
1 Insert the electrode holder (5) into the torch body (1) from the front.
2 Insert the tungsten electrode (3) into the electrode holder (5) from the front.
3 Hold the tungsten electrode (3) and the electrode holder (5) and tighten
the clamping element using a torque wrench.
 Tab. 9 Tightening torques on page EN-11.
4 Screw on torch cap (4).
5 Screw gas nozzle (2) onto torch body (1).
®
ABITIG WH 220WS
®
ABITIG WH 400WS
Tab. 9 Tightening torques
The electrode type is set by EN ISO 6848. The max. length of electrode
depends on the type of torch.
 3.1 Technical Data on page EN-5
NOTE
• The welding performance is affected by the selection of the tungsten
electrode and by wear. A smooth, groove-free sharpened end of the
tungsten electrode has a positive effect on the welding result.
1 Plug the cable assembly connection into the power supply and secure it with
a connection nut.
6 Putting into operation
max. 1 Nm
max. 1.5 Nm
EN - 11