Abicor Binzel TIG ABITIG WH Mode D'emploi page 32

6 Putting into operation
6.4 Mounting the TIG welding torch system on the robot
1 Torch clamp
2 Screw
3 Insulating jacket
Fig. 3 Mounting the TIG welding torch system on the robot
6.5 Setting the shielding gas
EN - 12
1
7
4 Screw
5 ABICOR BINZEL CAT torch
mount
1 Fasten the torch clamp (1) on the cylindrical shaft end of the insulating
jacket (3) with the screw (2).
2 Mount the torch clamp (1) with the screw (4), the disc (6) and the nut (7)
to the ABICOR BINZEL CAT torch mount (5).
For proper mounting of the CAT ABICOR BINZEL torch mount, please
observe the relevant operating instructions.
NOTE
• The type and quantity of the shielding gas depends on the welding task
and the gas nozzle geometry.
• To prevent the shielding gas supply from becoming clogged by
impurities, the cylinder valve must be opened briefly, before connecting
the cylinder. This will blow out any impurities that may be present.
• Make all shielding gas connections gas-tight.
1 Connect shielding gas cylinder to the current source.
2 Set the gas quantity on the pressure reducer of the shielding gas cylinder.
2
6
6
7
ABITIG
3
4
5
Disc
Nut
®
WH