Linea 2000 Domo DO924DV Mode D'emploi page 43

oor
oor
lips screwdriver, Flat bladed screwdriver, Hexagonal spanner.
a technician.
s unplugged and empty.
off, it is necessary to tilt the unit backwards. You should rest the unit on something solid
Before you reverse the door, you should ensure the appliance is unplugged and empty.
lips screwdriver, Flat bladed screwdriver, Hexagonal spanner.
slip during the door reversing process.
oor
s unplugged and empty.
d must be saved to do the reinstallation of the door.
off, it is necessary to tilt the unit backwards. You should rest the unit on something solid
it flat as this may damage the coolant system.
slip during the door reversing process.
2 people handle the unit during assembly.
1. Remove the screws on the back of the top cover.
lips screwdriver, Flat bladed screwdriver, Hexagonal spanner.
d must be saved to do the reinstallation of the door.
oor it flat as this may damage the coolant system.
s unplugged and empty.
2 people handle the unit during assembly.
off, it is necessary to tilt the unit backwards. You should rest the unit on something solid
slip during the door reversing process.
ews at rear side of top cover.
d must be saved to do the reinstallation of the door.
lips screwdriver, Flat bladed screwdriver, Hexagonal spanner.
it flat as this may damage the coolant system.
s unplugged and empty.
2 people handle the unit during assembly.
ews at rear side of top cover.
off, it is necessary to tilt the unit backwards. You should rest the unit on something solid
slip during the door reversing process.
d must be saved to do the reinstallation of the door.
it flat as this may damage the coolant system.
ews at rear side of top cover.
2 people handle the unit during assembly.
ews at rear side of top cover.
2. Remove the top cover and temperature control from the freezer.
er and thermostat knob, then place it aside.
er and thermostat knob, then place it aside.
er and thermostat knob, then place it aside.
er and thermostat knob, then place it aside.
ge and then remove door and place it on a soft pad to
ge and then remove door and place it on a soft pad to
3. Remove the three screws and then remove the top hinge that holds the door in place. Lift
the door and place it on a padded surface to prevent it from being scratched.
ge and then remove door and place it on a soft pad to
ge and then remove door and place it on a soft pad to
hinge. Then remove the adjustable feet from both
hinge. Then remove the adjustable feet from both
hinge. Then remove the adjustable feet from both
4. Remove the bottom screw, hinge bracket and adjustable foot from the bottom of the
appliance.
hinge. Then remove the adjustable feet from both
www.domo-elektro.be
7
7
7
7
unscrew
unscrew
unscrew
unscrew
43
DO924DV