Skil SRT1039 Guide D'utilisation page 20

Permanent Attachment to a
Workbench (Fig . 10)
1. Place the router table on a sturdy surface,
such as workbench.
2. While holding the router table in place, mark
the four locations of the fastening holes in
each of the legs onto the work surface.
3. Remove the router table.
4. Drill a Ø3/8"-15/32" (9.5mm-12mm) hole into the
workbench at each of the four marked locations.
5. Place the router table on the workbench and
align the holes in the table legs with the holes
in the workbench.
6. Secure the router table to the workbench with four bolts 5/16" (M8) x L and nuts (not included).
L=2-1/2" (63mm) for 1" thickness of workbench
–
L=3" (76mm) for 1-1/2" thickness of workbench
–
7. Tighten the bolts securely.
To Adjust the Cutting Depth (Fig . 11)
The router table features a depth-adjustment
hole to permit over-table depth adjustment
(OTA) for SKIL routers RT1322-00 (fixed base
only) and RT1323-00.
1. Loosen the motor clamp on the router.
See your router manuals for the detailed
instructions.
2. Insert a 4mm hex wrench (not included)
through the depth-adjustment hole and into
the depth-adjustment rod of the router, then
turn the hex wrench to move the router collet
down or up.
3. When the desired cutting depth is set, tighten
the motor clamp.
NOTE: See your router manuals for the detailed instructions about the motor clamp operation.
20
Fig. 10
Fig. 11
Fastening Hole
OTA