Skil SRT1039 Guide D'utilisation page 17

Installing the Quick-Clamp
Mounting Plate and Router to the
Router Table
WARNING
router is securely clamped in the router
table base. While working, periodically
check the router base fasteners clamping
tightness. Router motor vibration can loosen
fasteners during use, causing the router to fall
from the table.
1. Place the router table assembly upside down
on a flat, level surface.
2. Align the notches on the mounting plate with
the protruding parts on the table base, then
insert the edge of the mounting plate (with
two notches) under the pressing plate on the
table base (Fig. 5a).
3. Put down the mounting plate slowly until
its right edge is against the clamp-handle
of the router release mechanism and seats
flat on the table base. The clamp-handle
will snap in place to lock the mounting plate
automatically.
4. Flip the router table upright, with the legs
standing on a flat, level surface.
5. Align the four holes on the tabletop with the
holes on the mounting plate.
6. Insert the four Phillips screw assemblies
through the four holes in the router tabletop
surface and the holes in the mounting plate. Securely tighten the screws with the 5mm
combination wrench (Fig. 5b).
Installing the Insert Ring (Fig .6)
This router table includes three tabletop insert
rings with the following different opening
diameters: (G-1) 11/16" (17.5mm) opening
diameter, (G-2) 1-1/4" (32mm) opening diameter
and (G-3) 1-7/8" (44.5mm) opening diameter.
WARNING
cutting diameter of the bit and table so that
workpieces maintain full support of the table
while routing. The proper size insert ring
depends on the size and shape of the cutter.
When inserted, the insert ring opening should
be within 1/4" (6.3mm) of the outermost edge
of the cutter.
WARNING
that the difference is no less than 1/16" (1.6mm) on a side.
Before using the router
table, verify that the
Insert rings are meant to
reduce the gap between the
Do not alter insert ring or insert plate bit hole. Match the cutting diameter of
the bit to the inner diameter of the insert ring or insert plate bit hole such
Fig. 5a
Pressing
plate
Protruding
Notch
Part
Fig. 5b
Fig. 6
Clamp-handle
a
Tab
b
17