Skil SRT1039 Guide D'utilisation page 18

WARNING
The insert ring should fit into the tabletop hole completely. Use a fine file or emery board to
remove excess plastic or rough edges that may cause the insert ring to protrude above the
table surface.
1. Select the insert ring that best accommodates the router bit to be used.
2. Position the insert ring over the insert opening in the router table.
3. Press down evenly over the tabs until the insert ring locks into place.
4. To remove, pull up gently until the tabs disengage. When not in use, store insert rings in one
of the toolboxes or another convenient place.
WARNING
safety measures reduce the risk of unintentional tool operation.
Attaching the Fence Assembly to
the Tabletop (Fig . 7)
The fence comes pre-assembled. Loosen
the two fence assembly clamping knobs but
don't remove them from the two bolts before
attaching the fence assembly to the tabletop.
1. Attach the fence to the tabletop by inserting
the two round-head, square-neck bolts on
the fence into the holes of the keyhole slots
on the tabletop, making sure the bolt heads
are below the inner surface of the tabletop
and can slide freely within the keyhole slot.
2. Tighten the fence assembly clamping knobs
to secure the fence assembly in the desired
position.
NOTE: Use the scale on the tabletop as a guide when aligning the fence for routing operations.
Once the fence is positioned and aligned correctly, tighten the fence assembly clamping knobs
SECURELY.
Attaching the Miter Gauge (Fig . 8)
1. Attach the miter gauge to the table by sliding
the miter-gauge bar into the slot on the table.
2. To adjust the miter angle, loosen the miter
gauge knob, rotate the miter gauge to the
desired angle and tighten the knob again.
18
Do not use the router table with bits over 1-3/4" (44.5mm) in diameter. Bits
larger than 1-3/4" can contact insert plate or insert ring, throwing fragments.
Do not use, attempt to change, or remove tabletop insert rings from
the table unless the router is off and unplugged. Such precautionary
Fig. 7
Fence Assembly
Clamping Knobs
Keyhole Slot
Fig. 8
Bar
Bolt
Miter-gauge
Knob