Router Table Setup - Skil SRT1039 Guide D'utilisation

ROUTER TABLE SETUP

WARNING
Attaching the Legs to the Table (Fig . 2)
NOTE: The router table assembly has six hex socket bolts pre-installed on the table base for
attaching the two table legs.
1. Place the router table assembly upside down on a flat, level surface.
2. Loosen the three bolts on the right side of the table base.
3. Open the toolbox door and lower one of the legs onto the table base as shown. Make sure
that two bolts are inserted through the two holes in the toolbox.
4. Push the leg towards the center of the table, until the third bolt is inserted into the slot at the
center of the inner side of the leg. At the same time make sure that the tongue of the switch
mounting plate fits into the slot of the leg.
5. Tighten the three securing bolts with the included 5mm combination wrench.
6. Repeat the above process with the other table leg.
NOTE: The opening direction of both toolboxes should be on the side of the integrated safety
switch.
Fig. 2
Table base
Switch mounting plate
Removing the Quick-Clamp
Router Mounting Plate from the
Table Base (Fig . 3a and 3b)
This router table includes a quick-clamp router
mounting system, which has been pre-installed
at the factory prior to shipment.
1. Using the included 5mm combination wrench,
loosen and remove the four Phillips screw
assemblies which are securing the mounting
plate to the table (Fig. 3a). Save the bolts for
future use.
Always unplug the router table before attaching accessories or
making any adjustment.
b
Tongue
Slot
Fig. 3a
Toolbox
a
15