Skil SRT1039 Guide D'utilisation page 19

Attaching the Featherboards
NOTE: The front and back side of each featherboard is marked to indicate the proper feed
direction.
The featherboards come pre-assembled. Loosen but do not remove the large clamping knobs
from each bolt.
Attach the featherboard (without the slide bar) to the fence
1. Attach the featherboard to the fence by inserting the two round-head, square-neck bolts into
the slot in the fence, making sure the bolt head are snapped into the slot and can slide freely
(Fig. 9a).
2. Tighten the large clamping knobs to secure the featherboard to the fence (Fig. 9b).
Fig. 9a
Attach the featherboard (with a slide bar) to
the tabletop surface (Fig. 9c)
1. Attach the featherboard to the tabletop
surface by inserting the slide bar, attached
the feather board, into the slot on the table,
making sure the slide bar can slide freely
within the slot.
2. Tighten the large clamping knobs to secure
the feather board to the tabletop.
Fig. 9b
Feed Direction Mark
Fig. 9c
Slide bar
19