emerio Slow Juicer Mode D'emploi page 8

the blocked holes. If the strainer cannot be cleaned immediately after use, soak the strainer in hot soapy
water immediately after juicing is complete. If pulp is left to dry on the strainer, it may clog the fine mesh
holes and lessen the effectiveness of the juicer. Do not soak the strainer in bleach.
2. Wash the jar, hopper, pusher, pulp cup and juice cup in warm soapy water with a soft cloth. Rinse and dry
thoroughly.
Discoloration of the plastic parts may occur with brightly colored fruit and vegetables. To help prevent
this, wash parts immediately after use. If discoloration does occur, the plastic parts can be soaked in 10%
lemon juice and water or they can be cleaned with a non-abrasive cleaner. Do not soak the strainer in
bleach.
3. Wipe the motor base with a soft damp cloth and dry it thoroughly. Do not use abrasive scouring pads or
cleaners when cleaning the motor base as these may scratch the surface. Never immerse the motor base
into water or other liquid, nor rinse it under running water.
4. Wipe any excess food particles from the power cord.
5. All non-electric parts can be cleaned in a dishwasher ( temperature less than 75℃ ).
Note: Do not use heating devices to dry any part. Juice cup and pulp cup cannot be heated in a microwave oven.
Damage Check
Always check that the appliance is in good working order and that all removable parts are secure. Check the
power supply cord and plug regularly for cuts or damage.
Store in a Safe Place
In order to prevent the motor from damp, store the appliance in a cool and dry place.
TROUBLESHOOTING
Problem
The product is not
working.
The Juice does not
discharge
sufficiently or there
is juice discharging
from pulp ejector.
Check
Is the power cord connected?
Is the Juicer assembled correctly?
Has the power gone off?
Have you operated the Juicer for over
20 minutes?
Did you assemble the rubber pads
correctly?
Did you use fresh ingredients?
Did you put too many ingredients or
anything else into the machine?
Check if the power cord is plugged into a
220-240V 50/60Hz wall outlet.
Assemble the product as described in this
instruction manual.
Assemble the product as described in this
instruction manual.
Turn off the product. Wait for a while and
reactivate the product. If you want to use
the product continuously, pause the
operation for at least 30 minutes.
Assemble the rubber pads correctly as
described in this instruction manual.
Overripe fruits or vegetable may clog in the
product. If you want to use the overripe
ingredients, use them after soaking in
mineral water for 10 minutes or more.
Turn switch to "REV" for several seconds,
stop, then to "STA".
- 7 -
Possible Solutions