Using The Shredder And Slicer; Using The Emulsifying Disc - Brandt ROB506BG Manuel D'instruction

Operation
- Insert the mains plug in the socket outlet.
- Rotate the switch to "ON" position.
- Disengage and remove the lid only when the chopper blade has stopped rotating.
- Carefully remove the chopper blade and empty the bowl.
- When you have finished preparing your food, pull out the mains plug.
- Do not work with the chopper blade for more than 2 minutes at a time. After 2 minutes of
continuous operation, allow the appliance to cool down for 5 minutes.
- Do not attempt to cut or chop up hard food-stuffs such as coffee, ice etc., as this could damage the
chopper blade.
- Allow cooked foods to cool down slightly before placing them in the bowl.
- Remove any bones and tendons before putting meat in the bowl.
- Should you wish to process different types of foods, always start with the hardest one.
- Stop processing if you notice that bits of food are sticking to the walls of the bowl. Remove these
food pieces using a spatula.
b) Using the shredder and slicer
Assembly
- Insert the bowl as when working as a chopper.
- Place the disc stem (9). Then, put the shredding (9 or 10) or slicing disc (8) on the drive shaft.
- Put on lid (3) and engage in position.
Operation
- Rotate the switch to "ON" position.
- Put the food to be processed in feeding tube on lid (2). Insert pusher (6) in feeding tube. Using the
pusher, push the food slowly through the feeding tube and onto the shredding or slicing disc.
- When you have finished preparing your food, remove the mains plug.
- The shredding and slicing disc can be used on both slicing and shredding side. The side facing
upwards is the working side in each case.
- Do not work with the shredding and slicing disc more than 2 minutes at a time. After 2 minutes of
continuous operation, allow the appliance to cool down for 5 minutes.
- Do not attempt to cut or grate food such as tomatoes, lemons, dates, peaches, or frozen foods.
c) Using the emulsifying disc
Assembly
- Insert the bowl as when working as a chopper.
- Place the disc stem (4). Then, put the emulsifying disc (13) on the drive shaft.
- Put on lid (3) and engage in position.
Operation
- Rotate the switch to "ON" position,
- Put the food to be processed in feeding tube on lid (3). Insert pusher (6) in feeding tube. Using the
pusher, push the food slowly through the feeding tube and onto the emulsifying disc.
- When you have finished preparing your food, remove the mains plug.
18