Ibiza Light LAS1000G (15-1153) Manuel D'utilisation page 3

One unit has 12 channels, so each unit must be assigns 12 channels
at least
Loop Address
1 1 100000000
2 13 101100000
3 25 100110000
N (N-1)*12+1
The dipswitches setting for DMX address see the «DMX Address
Quick Reference Chart ".
DMX Control Parameter Chart
Channel No DMX512 fig.
Channel 1 Control
100-149
mode
150~255
Channel 2 Color select
Pattern
Channel 3
select
Channel 4 Vertical
128-191
move
192-255
128-191
Channel 5 Horizontal
move
192-255
Vertical
Channel 6
rotate
Horizontal
Channel 7
rotate
Channel 8 rotate 128-191
192-255
Channel 9 zoom
86-170
171-255
© Copyright LOTRONIC 2012
Binary Dipswitches
＃1
＃1 + #3+#4
＃1 + #4+#5
Content
0~49 Sound control
50~99 Auto- beam
Auto-animation
manual
0 Laser off
1-255 Color change
0-255 patterns
0-127 Manual
From down to up speedy
From up to down speedy
1~127 Manual
From right to left move
From left to right move
0-255 From slow to speedy
0-255 From slow to speedy
0-127 manual
Anticlockwise rotate
Clockwise rotate
0 static
1-85 From small to big
From big to small
Auto zoom
Channel 10 Pattern size
Channel 11 Spot and line
Twinkle
Channel 12
speed
PC Control
If it is set to ILDA mode (use PC software to control light), you just need to
connect the ILDA signal to the DB25 jack. ILDA mode (PC control) and
built-in program mode can be identified and transformed automatically.
Troubleshooting
1. If the power supply indicator doesn't light up and the laser doesn't work,
please check the power supply and the input voltage.
2. In Stand-Alone operation, the power supply indicator is light up and
sound active indicator isn't light up, but the laser doesn't work.
A. The volume of the sound is too low and the laser shuts off in
sound active mode. Please increase the music volume or increase
the audio sensitivity via the sensitivity knob.
B. Please check if unit has been set up in slave mode. Set it up in
master mode.
3. In Master-Slave operation, slave unit doesn't function, please check as
follows:
A. Make sure that there's only one master in the chain, and the
others are set in slave mode.
B. Only use a good quality power cable and connection.
4. In DMX mode operation, the laser is OFF and the DMX signal indicator
is OFF, please check as below.
A. Make sure to set the unit in DMX mode.
B. Make sure that you have a good connection.
5. In DMX operation, the unit can't be controlled by the DMX console, but
the DMX signal indicator is flashing: make sure DMX console and unit are
set to the same channel.
6. If the output beam direction above isn't the right way, please restart the
unit.
7. If the unit stops working, please turn it off and then turn it on again after
5 minutes.
8. In PC mode operation, the laser is OFF after the swimming fish, please
check as below
A. Please press the button of animation
B. Make sure the SD card is inserted and properly connected
After trying the above solution you still have a problem, please contact
your dealer or our company for service.
0 normal size
1-255 Small to big
0-255 Line to spot
0-22 Slow to speedy
Page 3