Correct Posture - Makita DUR365U Manuel D'instructions

Hex wrench storage
► 1. Hex wrench
When not in use, store the hex wrench as shown in the
figure to keep it from being lost.
OPERATION
Correct handling of tool
WARNING:
• Be extremely careful to maintain control of
the tool at all times. Do not allow the tool to
be deflected toward you or anyone in the
work vicinity. Failure to keep control of the tool
could result in serious injury to the bystander
and the operator.

Correct posture

WARNING:
• Always hold the both grips firmly and posi-
tion the tool on your right-hand side so that
the shaft of the left handle is always in front
of your body. Correct positioning of the tool
allows for maximum control and will reduce
the risk of serious personal injury caused by
kickback.
Fit the shoulder harness and hang the tool firmly on
your right side so that the shaft of the left handle is
always ahead of you.
Attachment of shoulder harness
1
1
► 1. Buckle 2. Hook
Wear the shoulder harness on your left shoulder. Make
sure that the buckle cannot be taken off with pulling it
off. Hang the tool as shown.
► 1. Buckle
The buckle is provided with a means of quick release.
Simply squeeze the sides of the buckle to release the
tool.
Adjustment of the hanger position
and shoulder harness
To change the hanger position, loosen the fixing screw
on the hanger with the supplied wrench and then move
the hanger and the cushion. The cushion can be moved
easily by twisting it.
MAINTENANCE
WARNING:
• Always be sure that the tool is switched
off and battery cartridge is removed before
attempting to perform inspection or main-
tenance on the tool. Failure to switch off and
remove the battery cartridge may result in seri-
ous personal injury from accidental start-up.
NOTICE:
Never use gasoline, benzine, thinner, alcohol or
the like. Discoloration, deformation or cracks may
result.
11 ENGLISH
2
1