Circle Cutter; Systainer; Maintenance And Care - Festool TRION PS 300 EQ Guide D'utilisation

15.1
15.2
A
B 16.1
The circle cutter (490118) can be used to produce
circular cuts with a diameter between 120 and 720
mm (4.7" - 28.3").
The circle cutter can be fi tted to either side of the
base runner:
15.3
- Turn off and unplug tool.
15.4
- Slide clamping clip [15.2] onto the base runner
- Insert circle cutter [15.3] through the clamping
- Tighten rotary knob [15.1].
- Insert circle tip [15.4] in the rear bore hole of the
Many Festool products are shipped in a unique
16
system container, called "Systainer". This provides
protection and storage for the tool and accessories.
The Systainers are stackable and can be interlocked
together. They also can be interlocked atop Festool
CT dust extractors.
To open the Systainer:
– Turn the T-loc [16.1] to the position
To lock the Systainer:
– Turn the T-loc [16.1] to the position
To connect two Systainers:
– Place one Systainer on the top of the other
– Turn the T-loc [16.1] to the position
The Systainers are connected and locked.
 A new generation Systainer is connectable on
quiring the motor housing to be opened may only
be carried out by an authorized service workshop.
Maintenance or repair work carried out by an unau-
thorized person can lead to the wrong connection of
the power leads or other components, which in turn
can lead to accidents with serious consequences.
10

Circle cutter

from the front.
clip from the side to the desired position.
circle cutter.

Systainer

(Fig. 16 A).
(Fig. 16 B).
top of a previous generation Systainer by the four
latches of the previous Systainer.

Maintenance and care

Any maintenance or repair work re-
.
.
or