Burner Use - baltur COMIST 72 DSPGM Manuel D'installation, Utilisation Et Entretien

BURNER USE

E
Burner operation is fully automatic.
N
the burner is started by closing the master switch
and the control panel switch. Correct burner ope-
G
ration is regulated using the command and control
devices, as described in the chapter "Operation
L
description". The "lock" position is a safety position
that the burner automatically assumes when a bur-
I
ner or system component is not working properly.
The burner may stay in the lock position without
S
any time limits. Locks may also be caused by tem-
porary inefficiencies. In this case, the burner will
H
restart normally.
It is recommended to check for anomalies in
the heating plant before restarting the bur-
ner. To release it, press the release button.
If locking continues to occur (3-4 times), do not con-
tinue with the operation. Check that the fuel arrives
normally to the burner and ask for assistance from
the after-sales service in your area.
DETAILS OF THE MODULATION CONTROL MOTOR SQM
10 - SQM 20 FOR REGULATING CAMS OF GAS AND MIXER
BURNERS
To modify the regulation of the cams utilized, operate the respective red rings (A - Z -
M - V). By pushing with enough force, in the direction desired, each red ring will rotate
with respect to the reference scale. The index of the red ring indicates on the respective
reference scale the rotation angle taken up foe each cam.
22 / 30
0006080115_200909
Reference index
Cam shaft
Adjustable cams
Maximum opening
end of the run
Total air closure
(burner at a standstill)
Air ignition opening
Principle feed valve(s)
B = Insertion and disinsertion lever
Motor connection - camshaft
Position 1 = Disinsertion
Position 2 = Insertion