Maintenance - Tunturi CROSS 3.0 Mode D'emploi

14. BODY FAT is a personal measurement and the result is
based on average european population values.
B.M.I. (Body Mass Index) table:
LOW / MEDIUM 20 - 24
MEDIUM / HIGH > 26,5
Formula for BMI = weight (kg) / height^2 (m)
BODY FAT % (average european population) table:
LOW / MEDIUM 13 - 26
MEDIUM / HIGH > 30
LOW / MEDIUM 23 - 36
MEDIUM / HIGH > 40
Cross 3.0_RD_manual.indd 6
LOW < 20
MEDIUM 24 - 26,5
Male:
LOW < 13
MEDIUM 26 - 30
Female:
LOW < 23
MEDIUM 36 - 40

MAINTENANCE

The equipment requires very little maintenance. Check,
however, from time-to-time that all screws and nuts are
tight.
After exercising, clean the equipment with a soft,
absorbent cloth. Do not use solvents. Never remove the
equipment's protective casing. The electromagnetic
brake forms a magnetic field that may damage the
mechanism of a watch, or themagnetic identification strip
on a credit or cash card,should they come into immediate
contact with themagnets. Never attempt to detach or
remove the electromagnetic brake! The electromagnetic
brake is based on electromagnetic resistance; resistance
level is electronically measured and shown as watt
reading on the display. Due to the measurement system,
your Tunturi crosstrainer need not be re-calibrated when
assembled, serviced and used according to this Owner's
Manual.
MALFUNCTIONS
Despite continuous quality control, defects and
malfunctions caused by individual components may
occur in the equipment. In most cases it's unnecessary to
take the whole device in for repair, as it's usually sufficient
to replace the defective part.
If the equipment does not function properly during use,
contact your Tunturi dealer/distributor immediately.
Always give the model and serial number of your
equipment. Please state also the nature of the problem,
conditions of use and purchase date.
If you require spare parts, always give the model, serial
number of your equipment and the spare part number for
the part you need. The spare part list is at the back of this
manual. Use only spare parts mentioned in the spare part
list.
6
9/24/2012 8:55:32 AM