Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
determine a proper distance is to turn mode switch to Test and
to walk perpendicularly to the front of the camera where action
is anticipated. When the detector is activated, the test light on
the front of the camera will blink once. At this moment, the
camera operator may want to adjust the distance setting, and/or
change the direction or height of the camera.
DOWNLOAD TO A COMPUTER
To transfer or view photos and videos on a PC, camera must
first be turned off, and a USB cable used to connect camera to
computer. The computer will then recognize the camera as a
removable disk drive. Camera operator must wait termination
of computer software installation (few seconds) before clicking
on Desktop. Then, click on removable disk and look to find
folder with DCIM. Click on that and all photos and videos
will be found in 100DSCIM folder. Photos and videos can be
viewed, edited or deleted with own computer software.
Taking the SD card out of the camera and inserting it in the
computer port will achieve same results. If no SD slot is built-
in the computer, a multi-card reader
RD25-1 (sold separately) must be used.
6
DISTANCE
The distance dial sets the motion detector
sensitivity.
Use this feature to set the
detection range required. Turn dial to the
right to increase distance. Range of detector
is between 5 and 50 ft. Best method to
Publicité
Table des Matières
