VERITAS Florence Mode D'emploi page 85

1
1
2
If you are using adhesive stabilizers, place
the adhesive surface of the stabilizer material
1 against the wrong side of the fabric, and iron.
①
Wrong side
②
2
Stabilizer
③
Adhesive surface
3
v Hooping the fabric
Thick layers of fabric and stabilizer may
cause skipped stitches, or broken threads,
needles and damage on embroidery hoops.
Loosen the fastening screw under the outer
hoop.
Separate the inner hoop and outer hoop.
①
Fastening screw
Place the outer hoop on a sturdy flat space.
Make sure the fabric with right side upwards,
place the stabilizer underneath the fabric for
better support, and then place the fabric and
stabilizer altogether on the outer hoop. It can
achieve better embroidery performance.
Align both triangular marks and fix the fabric
in place.
①
Inner hoop's triangular mark
②
Outer hoop's triangular mark
79
n Attention
EN