VERITAS Florence Mode D'emploi page 63

6. Push the bobbin to the right. When the
bobbin winder spindle is pushed to the
right, the screen will show "SP".
7. Hold the thread tail securely in one hand.
Step on the foot control (only in the
sewing mode) or long press the start/stop
button to start winding the bobbin.
8. After the bobbin has wound a few rounds,
stop the machine and cut the thread near
the hole of the bobbin. Continue filling
the bobbin until it is full. Once the bobbin
is full, it rotates slowly. Release the foot
control or press the start/stop button to
stop the machine, then push the bobbin
winder spindle to the left.
9. Cut the thread and then remove the
bobbin.
When the bobbin winder spindle is pushed
to the right position, it's in "bobbin winding"
mode and the machine is not allowed to
sew and the handwheel will not be able
to turn. To start sewing, push the bobbin
winder spindle back to the left.
Use a bobbin that has been correctly
wound with thread, otherwise the needle
may break or the thread tension will be
incorrect.
57 57
Note
Note
EN