Bosch BCR1 Série Mode D'emploi page 80

Cleaning programmes and operating modes
12
80
SPOT cleaning programme
12
Fig.
With the SPOT cleaning programme, the robot vacuum
thoroughly cleans an area measuring approximately 1
2
m .
When operating the robot vacuum using the buttons, it
must be placed in the centre of this area; when using
the Home Connect App, the robot vacuum will move
to this area automatically. The robot vacuum will then
move over and clean this area in parallel lines.
Once the area has been cleaned, the robot vacuum will
return to where it started.
Only the Power operating mode can be set for this
cleaning programme.
You can find detailed information about the operating
modes in the „Operating modes" section. Fig.
Cleaning programmes in the Home Connect app
The following programmes can only be called up in the
Home Connect app:
Room Select
On a digital map, select individual rooms that should
be cleaned.
No-Go zone
Specify areas that should not be cleaned.
VirtualCleaning
Plan your cleaning tasks with ease.
!
Information
For safety reasons, the Roxxter only starts the
cleaning plan from the charging station.
Go To
On a digital map, select the position that the Roxxter
should go to.
en
17