Inserting And Placing The Hearing Aid; Troubleshooting; Regulatory Compliance - Microson CIMA FRONT BTE Manuel De L'utilisateur

INSERTING AND PLACING THE HEARING AID
1 2
1. Carefully insert your custom made moulds into the
ear canal.
2. Place the hearing aid behind the ear.
3. Check that the device is correctly supported.
CUSTOM MADE MOULDS
WARNING!
•
Risk of injuries caused by incorrect use of the custom
made moulds.
•
Always use the standard tube with the custom made
mould.
•
Make sure that the custom made moulds are
correctly attached to the standard tube.
•
If the custom made mould becomes lodged in the
ear, ask a medical professional to remove it.
•
Carefully insert the custom made mould in the ear
without inserting it too far.
•
Only use the standard tube and the custom made
mould as described in this User Manual.
EN EN
3
36 36
SYMPTOM POSSIBLE CAUSE
Expired battery
The hearing aid
does not work
Defective hearing
Mould blocked or
Insufficient volume
obstructed
Sound distorted or
Worn battery
unclear
Manufacturer's
customer service:
NOTE
For any other problems
audioprosthologist or retailer.
REGULATORY COMPLIANCE
The CE Mark enables Microson to confirm that
its hearing aids comply with European Directive
93/42/EEC concerning medical devices.
37

TROUBLESHOOTING

SOLUTION
Replace battery
Consult your
aid specialist
Eliminate
obstruction and
clean the mould
Replace battery
+34 93 300 58 00
helpdesk@microson.es
or doubts, contact your
EN