Positioning The Logs; Fitting The Glass Panel; Mounting The Front Panel Concerto; Mounting The Front Panel Concerto Vision - Dru Verwarming CONCERTO Instructions D'installation Et Mode D'emploi

INSTRUCTIONS FOR INSTALLATION

Positioning the logs

Special vermiculite and chips have been developed for the
Concerto Vision to create a decorative black appearance.
You have the option of using either the vermiculite, chips
and embers from the log set, or the black accessory set
with black vermiculite and chips especially designed for the
Concerto Vision.
NB: Do not use both!
Position the logs as follows:
• Lay the large log against the back wall, on the log
supports, as indicated in fig. 5.
When you use the vermiculite, chips and embers from the
log set:
• Fill the burner with vermiculite.
• Spread it evenly over the burner tray and the surrounding
tray.
• Sprinkle the brown embers, to create a glowing effect on
the burner bed, and the chips (black and yellow) on the
top of the vermiculiet on the burner.
When you use the black accessory set:
• Fill the burner with vermiculite.
• Spread it evenly over the burner tray and the surrounding
tray.
• Sprinkle the black chips on the top of the vermiculiet on
the burner. • It is important to first sprinkle the
vermiculite on the burner tray and then the chips, as this
will give the best flame effect.
• Make sure that no vermiculite gets on or into the pilot
light burner, as this could prevent it from working
properly.
• Now lay the rest of the logs in place as illustrated in fig. 5.
The logs should not be laid in any other way as this could
cause the formation of soot. Neither should the logs touch
pilot light burner.
You can "play" with the flames by moving the vermiculite,
embers and chips about on the burner bed until you have
created the desired flame effect.
Do not use any materials other than those supplied.The
supplied materials are incombustible and have been
manufactured specifically for this appliance.

Fitting the glass panel

Once the logs are in place, the glass can be replaced in the
brackets nges and tightened with the two socket-head
bolts. In the event of damage or breakage, the glass should
be replaced immediately.
Mounting the front panel Concerto (fig. 9a)
The coloured or stainless steel frame (A) is packed
separately from the basic set.The frame is fitted to the
front panel (B) using the 8 bolts supplied (C). Make sure
that the tall edge is at the bottom.

Mounting the front panel Concerto Vision

(fig. 9b)
The front panel is packed separately to the basic set, and
fitted as follows.
Remove the magnets to the basic set.
Fix the mounting frame (A) to the base set with the sheet
metal screws (B).
Now hang the front frame (C) onto the mounting frame.
For safety reasons a guard should be placed in
front of the fire at all times.
A
C
16
Tall edge
fig. 9a
B
38c-1063
fig. 9b