Innotek CY0993 Guide D'emploi page 4

If it is necessary to change the yard size setting:
1. Turn the Field Width knob to the "off" position.
2. Remove the knob and the four screws that secure the transmitter's cover.
3. Move the jumper to the desired yard setting. The jumper must be in place for the transmitter to function.
• Rechargeable Systems Only: The jumper is located
at the lower left side of the transmitter. SM is for small yards;
LG is for large yards (see Figure 1).
• Battery-Operated Systems Only: The jumper is located
at right side of the transmitter. SMALL is for small yards; LARGE
is for large yards. A second jumper is labeled "DUAL FREQ"
and "8.192 KHz." This jumper should always be in the "8.192 KHz"
position unless otherwise directed by an Innotek Service Center
(see Figure 2).
4. Replace the transmitter cover and the four screws.
5. Reinstall the Field Width knob with the pointer in the "off" position.
STEP 6.
LAY OUT THE PERIMETER WIRE
IMPORTANT NOTE: Do NOT bury the wire until you have tested the system and are sure it
is working properly. Do NOT nick or scrape the wire during installation. Improper function
may result.
1. Use your drawing as a reference. Begin laying the wire around the perimeter of your containment
area to form a continuous loop. Use gradual turns at the corners with a minimum of 1meter radius.
This provides a more consistent signal field.
2. If you are using more wire than initially supplied with your
containment system, the wire connections must be water-
proof
to provide a sealed connection between the wires. Use only
the supplied splices or a comparable type. Do not use electri-
cal
tape or twisted wire nuts. This will cause an intermittent sig-
nal
or disarm the system.
3. Continue around your perimeter until you return to the
start of the loop.
4. Cut the wire.
SM
SM
Figure 1
Rechargeable System
Figure 2
Battery-Operated System
Wall Transmitter
Located in Garage
Installation Diagram
4
LG
LG
SM LG
Perimeter Wire
Twisted Wire
to Wall
Transmitter
MED LO