Innotek CY0993 Guide D'emploi page 2

SECTION 1.
INSTRUCTIONS FOR SETTING UP YOUR CONTAINMENT SYSTEM
This owner's manual covers the instructions for both the battery-operated collar receiver and
rechargeable collar receiver containment systems. Throughout this manual are notes pertaining to
each of these system types.
STEP 1.
PREPARE A LAYOUT OF YOUR CONTAINMENT AREA
A. Design and Draw Diagram
Prepare a diagram of the area you want to contain your dog. A diagram will help to avoid unfore-
seen obstacles. Include the location of house, driveway, pond, garden, swimming pool, etc. If your
neighbor has a containment system installed, mark the location of the buried wire on your diagram.
B. Contact Utility Company
Contact your utility companies to mark any buried utility lines. Be sure to include the buried lines on
your drawing because these utility lines will affect the placement of your wire.
C. Determine Location of Wall Transmitter
The transmitter can be mounted to a wall near any standard 220-volt household outlet with the
included screws. It will withstand freezing temperatures, but it is not waterproof. Therefore, it is best
to locate the transmitter in an enclosed area.
NOTE FOR RECHARGEABLE SYSTEMS: The wall transmitter must be mounted in an environment
where the ambient temperature is between 0 degrees C and 45 degrees C.
D. Determine the Exit Route of Your Boundary Wire from the Transmitter to the Outside Containment
Area
Since your transmitter must be mounted in an enclosed area to protect it from the weather, give
careful consideration on where the wire exits to the exterior. Existing openings such as a window,
door or utility line hole may provide easy access to the outside. You may need to drill a hole through
the exterior wall.
STEP 2.
ADD PROPOSED WIRE LOCATION TO YOUR DRAWING
Mark your diagram with the proposed location of your wire. This will provide an easy reference as
you install the wire.
To allow back door entry To keep dog away To enclose the entire property
with back yard containment. from a specific area. and protect a selected area.
Example Installation Diagrams
2