Innotek CY0993 Guide D'emploi page 13

C. To Locate Wire Breaks:
To locate wire breaks in the loop installation, use a wire break location device called a RF- Choke. It
is available through the RadioShack® (Catalog #273-102C). Once you have this device, follow these
steps:
1. Disconnect the power by unplugging the adapter from the outlet.
2. Disconnect the wires from the wall transmitter.
3. Bend the leads of the RF-Choke into the shape of a horseshoe.
4. Gently wrap the wire (stripped) ends around the
RF-Choke leads (one to each side).
5. Plug the RF-Choke leads into the terminals on the transmitter.
6. Plug the adapter into the outlet.
7. Set a portable radio to a frequency near 600 kHz on the AM band.
8. Set the field width knob high enough to obtain a signal on the portable radio when holding the
radio over the containment wire.
9. The signal should be absent on the twisted wire portions because twisting cancels the signal.
When you reach a single wire area of your boundary, listen for pulsating static on the radio.
10. Hold the radio chest high and swing the radio over the wire as you walk along the boundary.
11. If the tone stops, weakens, or changes pitch, mark the spot with a flag or stick. No sound indi-
cates a complete break in the wire. If the signal fades or changes in pitch, look for a nick in the
insulation.
12. Continue around the remaining boundary and mark each signal change with a flag or stick.
13. After completing the entire boundary, return to the marked spots. Examine the wire for 3 to 4
feet in each direction.
14. Replace the damaged wire using the same gauge wire used in the original installation and use
waterproof wire splices to make the connection.
For more information, visit our web site at www.innotek.net.
LIMITED INTERNATIONAL WARRANTY
Innotek ™ warrants that its products will be free from defects in material and workmanship under normal use for
one year from the date of original consumer purchase.
Within 30 days of the original consumer purchase, products are covered by Innotek's 30-day money-back guaran-
tee and/or local country consumer law. If you are not satisfied with the performance of the product, you may return
it with the original receipt to the place of purchase for a full refund.A refund is subject to the retailer's return policy.
After 30 days and during the Limited Warranty period, products covered by this Limited Warranty will be repaired
by an Innotek-authorized Service Center for a nominal processing fee. Shipping costs to the Service Center are not
covered by this Limited Warranty.
The returned item must be accompanied by a copy of the original receipt showing the place and date of purchase.
This Limited Warranty is offered only to the original consumer purchaser.This Limited Warranty is subject to the
condition that any covered defect occurs under normal conditions of use and maintenance and that Innotek
receives prompt written notice of the discovery of the defect within the Limited Warranty period. It does not apply
to damage or failures that result from physical abuse or misuse of the product.The Limited Warranty is void if any
13