Urmet 1099 Guide Rapide page 12

7. If you want the camera to record and store video files on a micro SD card (not included),
plug the micro SD card into the slot when the camera is powered off. Power on the
camera and use the camera's wepgabe or the app to format the card before starting the
recording function.
If you are using a NVR/HVR device it is advisable to assign a static IP address to the
camera: see section 4.5 of this guide to perform this operation.
4.4 HOW TO ADD THE CAMERA TO A WIFI NETWORK USING AP MODE AND
PC
This mode is used to configure the wireless network interface of the camera without wiring it to
the network. It is an alternative to section 4.3.
The camera is automatically set to Access Point mode if it was never configured in a WiFi
network. A PC
In this case, network configuration may be performed after having fitted and powered the camera
in its final position.
The following steps must be performed for configuration:
1. Search from the available WiFi networks on the PC. The camera has a
SSID. Select this SSID to connect the PC to the camera.
2. Run steps from 1 to 6 described above in section 4.3.
3. When the camera connects to the configured WiFi, it stops working in Access Point
mode and disconnects from the PC. For this reason, the PC must be connected to
the LAN before pressing the
detect the camera again in the network.
Run step 8 described above in section 4.3.
4.
12
with wireless network board
" "
Refresh List button of the
is needed to
"
EasyTool
configure it.
" "
URM_
"
program and
DS1099-008A