Urmet 1099 Guide Rapide page 10

4.2 HOW TO ADD THE CAMERA TO A CABLED NETWORK AND CONNECT
FROM THE APP
Use the LAN cable to connect the camera to the internet router then power the camera, it will get
a dynamic IP address assigned by the router's DHCP service. If the DHCP service is not available
on the network, the camera will automatically assign the default IP 192.168.1.168 to itself.
Download the URMET App V-Stream from the store and use it to connect to the camera by
simply scanning its QR code label, then it will be possible to display the camera's pictures on the
smartphone through the internet.
4.3 HOW TO ADD THE CAMERA TO A WIFI NETWORK USING LAN CABLE AND
PC
Use a network cable to connect the camera to the LAN and power it. The camera will receive an
IP address assigned automatically by the DHCP service of the network. If the DHCP service is
not available on the network, the camera will automatically assign the default IP 192.168.1.168
to itself.
The following steps are needed for configuration:
"
1. Start EasyTool
mask, gateway and MAC address of each IP camera active on the LAN will be
automatically displayed, as shown in the figure below.
2. After having detected the IP camera, right click and select
to open a Web page on IE.
See the applicable section in the complete manual if installation of an ActiveX
component is required.
You can select user name (default: admin), password (default: admin), stream type
(Main/Sub/Mobile Stream) and language on the log in page.
10
"
on the PC by selecting : the IP address, subnet
" "
open in IE (aprire in IE)
DS1099-008A