Seagate NAS OS 4 Manuel D'utilisation page 94

Remove the network UPS server
Choose Remove the network server to disconnect a NAS from the network UPS server.
Mul ple NAS devices B: The UPS is the network UPS server
The following configuration requires a UPS with an Ethernet port to connect to the same router as the NAS
OS devices. Additionally, the UPS must support SNMP to communicate with the NAS OS devices on the
network. Refer to your UPS's documentation for further details.
The instructions below suggest adding all NAS OS devices at once. However, you can connect each NAS OS
device as required by your working environment.
1. Connect the UPS to a power source and the network router according to the instructions provided in the
UPS's documentation.
2. Confirm that no one is accessing the NAS OS devices and power them off.
3. Connect the NAS OS devices to the UPS via power cables only and power them on.
4. For each NAS OS device, go to the Power page and choose Add a network UPS server.
5. In the pull-down menu for Network UPS type, select SNMP UPS.
6. Enter the UPS's IP address and, if applicable, SNMP community. Refer to the UPS's administration tool for
its IP address.
7. Choose Save.
NAS OS cannot adjust the battery threshold level when connecting to a UPS server via the network. Check
Seagate NAS OS 4 6/1/20 95