Po Rt Aggregatio N: Lan Failo Ver Fo R Lo Ad Balancing Versus Fault To Lerance; Proxy Tab; Remote Access Tab - Seagate NAS OS 4 Manuel D'utilisation

disabled LAN port to make the Edit pull-down menu visible and choose Enable.
Port aggrega on: LAN failover for load balancing versus fault
tolerance
Both bonding and fault tolerance can save you from losing productivity should a single LAN fail (e.g. NAS port,
router port, or cable). In the event of LAN failure in a load balance bond, it can take a few minutes for the
NAS to switch to single LAN mode. Fault tolerance will make the switch instantly, allowing for uninterrupted
communication with the NAS.

Proxy tab

A proxy server is used to connect network devices to the Internet. If necessary, your NAS can be configured
to use a proxy server.
1. Click on the Internet access pull-down menu and choose Proxy server.
2. Complete the fields for the proxy server's IP address, port, and optional authentication information.
3. Choose Apply.

Remote access tab

Seagate NAS OS 4 6/1/20 89