Half Tone Transposition; Tone Control; Using Drawbar Settings From Memories; Panel Controls From Memories - Key B Organ Viscount Legend Expander Mode D'emploi

6.2 HALF TONE TRANSPOSITION

The transposition can be set within a range from -6 to +5 semitones:
1.
Press the [REVERB] and [ROTARY] buttons simultaneously until the display shows the message "trA".
2.
Press [VALUE +] or [VALUE -] to adjust the value ranging from " -6" (-6 semitones) to "
transposition) to "

6.3 TONE CONTROL

In the original electromechanical organs equipped with the AO-28 preamplifier, there is a TONE CONTROL
knob that allows you to greatly modify the frequency response by attenuating the high frequencies.
Exp
has a parameter that simulates the Tone Control of electromechanical organs.
1.
Press the [REVERB] and [ROTARY] buttons simultaneously until the display shows the message "tCn".
2.
Press [VALUE +] or [VALUE -] to adjust the value ranging from "
attenuation) to "127" (no effect).

6.4 USING DRAWBAR SETTINGS FROM MEMORIES

As described in par. 4.9., Memories also store the drawbars values for the three sections, according to the
position of each drawbar when the configuration was saved. When a Memory is recalled, these values are
loaded and thus the sound is immediately modified. However, the LOCK DRAWBARS function, prevents the
instrument from loading the drawbar values from Memories.
1.
Press the [REVERB] and [ROTARY] buttons simultaneously until the display shows the message "Lod".
2.
Press [VALUE +] or [VALUE -] to select:
- "off": function disabled.
- " on": function enabled.

6.5 PANEL CONTROLS FROM MEMORIES

As described in par. 4.9, Memories also store the values of the panel controls as they were set in the moment
the configuration is saved. When a Memory is recalled, these values are applied and thus the sound is
immediately modified. However, the LOCK CONTROLS function prevents the instrument from loading the
[REVERB], [DRIVE] and [VIBRATO / CHORUS] values from Memories. The Reverb level, Drive effects and the
type of Vibrato or Chorus are not modified when a Memory is recalled.
1.
Press the [REVERB] and [ROTARY] buttons simultaneously until the display shows the message "LoC".
2.
Press [VALUE +] or [VALUE -] to select:
- "off": function disabled.
- " on": function enabled.
6.6 CONFIGURING THE PEDAL OR HALF MOON SWITCH CONNECTED
TO THE [ROTARY] CONNECTOR
As described in par. 3.2, it is possible to use a switch pedal or an external Half Moon switch, connected to the
[ROTARY] connector on the rear panel, to control the Rotary effect speed. Use the ROTARY PEDAL MODE
function to set the operating mode of the pedal or the type of Half Moon switch ("direct" or "inverse", see the
image below).
1.
Press the [REVERB] and [ROTARY] buttons simultaneously until the display shows the message "rPM".
2.
Press [VALUE +] or [VALUE -] to select:
- "sWt": SWITCH mode, the rotation speed is selected each time the pedal is pressed, as described in
the table at point 3 of par.3.2.
- "MoM": MOMENTARY mode, the rotation speed is changed only while the pedal is pressed. As soon as
the pressure on the pedal is released, the Rotary returns to the previously selected speed as
5" (+5 semitones).
EN - 21
User Manual
0" (maximum high frequencies
0" (no
Legend