Key Click; Setting The Equalizer; General Settings; Fine Tuning - Key B Organ Viscount Legend Expander Mode D'emploi

User Manual

KEY CLICK

Another flaw that has become part of the sound is the click of the keys (Keyclick) at the attack of the note,
generated by the switch located under each key.
1.
Press the [MODEL] button until the display shows the message "KCl".
2.
Press [VALUE +] or [VALUE -] to adjust the value, ranging from "0" (no keyclick noise) to "127" (maximum
keyclick volume).

5.8 SETTING THE EQUALIZER

The equalizer can be adjusted through the following parameters:
- BASS ("bAs" on the display): adjust the low frequencies.
- MIDDLE ("MId" on the display): adjust the middle frequencies.
- TREBLE ("trE" on the display): adjust the treble frequencies.
1.
Press the [EQ] button until the display shows the frequency band you want to adjust as described above.
2.
Press [VALUE +] or [VALUE -] to adjust the value, ranging from "-15" (maximum signal attenuation in the
selected frequency band) and "
selected frequency band).
All the general setting of the instruments can be found in the GLOBAL section of the internal parameters.
For your convenience, all parameters are printed on the upper part of the front panel, together with their short
names as they appear on the display. The same table can also be found in this manual at the beginning of
chapter 5.
To access the settings of the GLOBAL section, press the [REVERB] and [ROTARY] buttons simultaneously.
To scroll through all the GLOBAL settings, press the same buttons again repeatedly until the desired setting
appears on the display. Follow the instructions at the beginning of chapter 5 to cycle through parameters.
The general settings are:
- TUNING ("tUn" on the display): adjust the fine tuning of the instrument.
- TRANSPOSE ("trA" on the display): adjust transposition by half tones.
- TONE CONTROL ("tCn" on the display): adjust TONE CONTROL.
- LOCK DRAWBARS ("Lod" on the display): prevents from loading the drawbar values from Memories.
- LOCK CONTROLS ("LoC" on the display): prevents from loading the panel controls values from
Memories.
- ROTARY PEDAL MODE ("rPM" on the display): set the operating mode of the pedal connected to the
[ROTARY] port.
- EXPRESSION PEDAL TYPE ("EPt" on the display): select the type of expression pedal connected to the
[EXP] connector.
- EXPRESSION PEDAL MIN ("EPM" on the display): level of the expression pedal connected to the [EXP]
connector, when the pedal is at its minimum.

6.1 FINE TUNING

Adjust the fine tuning of the instrument in a range from -50 to +50 hundredths of half tone:
1.
Press [REVERB] and [ROTARY] simultaneously until the display shows the message "tUn".
2.
Press [VALUE +] or [VALUE -] to adjust the value in a range from "-50" (-50 hundredths of half tone) to "0"
(A3 at 440 Hz) to " 50" (+50 hundredths of half tone).
Legend Exp
0" (no gain nor attenuation) to " 15" (maximum signal gain in the

6. GENERAL SETTINGS

EN - 20
allows the user to adjust the Keyclick volume.