Key B Organ Viscount Legend Expander Mode D'emploi page 37

- [VALUE +] and [VALUE -]: increase or decrease (respectively) the value shown on the display.
- [REVERB] + [ROTARY] (GLOBAL): press these buttons simultaneously to access the system
parameters.
- [ROTARY] + [DRIVE] (MIDI): press these buttons simultaneously to display the MIDI interface settings.
6. PERCUSSION section.
These controls enable and customise the percussion sound on the Upper section:
- [ON/OFF]: activate (led on) and deactivate (led off) the percussion.
- [SOFT/NORM]: select one of the two percussion levels. In NORMAL mode (led off) the volume of the
percussion is set with the potentiometer PERCUSSION VOLUME parameter (see par. 5.5). In SOFT (led
on) the volume is attenuated.
- [FAST/SLOW]: switch between two percussion decay durations. In SLOW mode (led off) the decay time
is set by the PERCUSSION DECAY parameter (see par. 5.5). In FAST mode (led on) the decay time is
shorter.
- [2nd/3rd]: select the percussion harmonic. 2ND (led off) selects the second harmonic (equivalent to a 4
'register), 3RD (led on) selects the third harmonic (equivalent to a 2 2/3' register).
For further information on the percussion read par. 4.3.
7. Drawbars.
Adjust the sound of the selected section using the DRAWBARS buttons (see point 8). For further
information on drawbars, read par. 4.2.
8. DRAWBARS section.
Select the organ section controlled by the drawbars (see point 6).
- [UPPER]: select the Upper section, representing the upper manual of the organ.
- [LOWER]: select the Lower section, representing the lower manual of the organ.
- [PEDALS]: select the Pedals section, representing the organ pedalboard.
9. PRESETS section.
Choose a Preset for the selected section. Sections are selected using the buttons of the DRAWBARS
section. For more information on Presets see par.4.8.
10. VIBRATO/CHORUS section.
Select a Vibrato or Chorus effect with the [VIBRATO/CHORUS] knob (see point 4) and then use these
buttons to assign this effect to the Upper section ([UPPER
For more information on the Vibrato and Chorus effects see par. 4.4.
([LOWER] button).
11. MEMORY section.
Use these buttons to select and store Memories.
- [STORE]: press this button and a Memory button ([1] to [5]) to save a Memory. Press a PRESETS
section button (see point 9) to save a preset.
- [BANK]: press this button and one of the Memory buttons ([1] to [5]) simultaneously to select one of the
5 Memory banks.
- [1] ... [5]: each of these buttons recalls a specific Memory. The led light indicates the currently selected
Memory.
For more information on Memories see par. 4.9.
12. ROTARY section.
Use these buttons to switch between the two speeds ([SLOW] and [FAST]) of the internal rotary effect, to
simulate the sound generated by the classic rotating speaker used with electromechanical organs. To stop
the speaker rotation (Brake mode), press the currently selected speed button (indicated by the led on).
Brake mode is also indicated by the leds off of both buttons.
For more information on the Rotary effect, see par. 4.7.
button
] ) and / or to the Lower and Pedals section
EN - 5
User Manual