Hexagon TESA RUGOSURF 90G Mode D'emploi page 90

The submenu used to set the parameters RPc, PPc or WPc has a different structure.
This window is divided into 4 parts:
a) Up left Name of the relevant roughness parameter
b) Bottom left Enabling/disabling the chosen parameter
c) Top right Choosing a limit value (absolute or relative) and setting the measuring range. The value Abs is expressed
in microns whilst the value Rel is a percentage in relation to Rt - Pt - Wt.
The procedure for entering both limit values and tolerance values is identical.
d) Bottom right Entering both upper and lower tolerance limits.
Finally, press to confirm your entries.
The submenu used to set R
This window also includes 4 parts:
a) Top left Name of the relevant parameter
b) Bottom left Enabling/disabling the chosen parameter
c) Top right Choosing both limit values Rmr1 and Rmr2 (resp. Pmr1 and Pmr or Wmr1, Wmr2). Each value is a
percentage of the sum of the peak height within the predefined zone compared to the total length.
d) Bottom right Entering both upper and lower tolerance limits.
Press to confirm your settings or
you'll automatically get back to previous menu.
12
c, P c or W c looks like the example below:
  
to quit. If so, neither of them will be saved. Whichever key you choose,
TESA Rugosurf 90 G