Installation In Multiple Combinations - REV MAX! Mode D'emploi

• If you are working with a stone wall, drill the marked
two 5 mm holes and insert the plugs supplied. If
you are working with a wooden wall, you can pre-
drill 1.5 mm holes to make screws easier to insert.
• Use the screws and plugs supplied to fasten the
mounting plate to the wall.
• Next, attach the frame to the mounting plate.
• Attach the Wall Thermostat. Make sure that the ar-
rows on the back side point upwards and that the
clips on the mounting plate latch into the openings
on the electronic unit.

8. Installation in multiple combinations

You can mount the MAX! Wall Thermostat with the attachment
frame provided or use it with frames of other manufacturers as
well as integrate the electronic unit into a multi-gang frame. In
both cases, mounting with adhesive strips and screws is possib-
le. For mounting with multiple combinations, make sure that the
mounting plate of the Wall Thermostat is seamlessly aligned to
the already fixed mounting plate/retaining ring.
The MAX! Wall Thermostat is designed to fit into frames supplied
by the following manufacturers:
Manufacturer
Berker
ELSO
GIRA
merten
JUNG
A
B
B
B
B
Frame
S.1, B.1, B.3, B.7 Glas
Joy
System 55, Standard 55, E2,
E22, Event, Espirit
1-M, Atelier-M, M-Smart,
M-Arc, M-Star, M-Plan
A 500, AS 500, A plus, A creation
A
33