REV MAX! Mode D'emploi page 32

Adhesive strip mounting:
• Choose a site for installation. The surface on which
you are mounting the Wall Thermostat must be
clean, dry and greaseless.
• For mounting of the assembled Wall Thermos-
tat, attach the adhesive strips to the back side of
the mounting plate. You should be able to read
the letters on the back side (according to figure).
• Remove the protective film from the adhesive strip.
• Press the assembled Wall Thermostat with the back
side to the wall in the position where it should sub-
sequently be attached.
Screw mounting:
• Choose a site for installation.
• Make sure that electrical lines in the wall will not
be damaged.
• Position the mounting plate on the desired site on
the wall. Make sure that the arrow on the mounting
plate is pointing upwards.
• Use a pen to mark the positions of 2 bore
holes A (diagonally opposite) in the moun-
ting plate on the wall. The bore holes B can be
used for installation with a flush-mounting box.
32
<PA66>