KitchenAid KVWC956KSS0 Instructions D'installation Et Guide D'utilisation Et D'entretien page 9

Install Range Hood Internal Blower Motor
IMPORTANT: The blower has to be installed before installing the
hood to the wall.
1. Install the range hood blower motor assembly inside the
range hood with the wiring connection to the left for the
single motor system and to the front or top for the dual
motor system.
Single Blower Motor Assembly
A
A. Wiring connection
Dual Blower Motor Assembly
A. Wiring connection
2. Slide the left mounting plate flange under the motor
3. Run the power supply wires and connector from the range
A
4. Push the right end of the motor mounting plate up and snap
mounting bracket.
A B
A. Motor mounting bracket
B. Mounting plate left flange
hood through the hole in the right end of the motor mounting
plate.
A. Motor mounting plate
B. Power supply wires and connector
it into the spring tab.
NOTE: The spring tab should be outside the slot in the
mounting plate.
A. Motor mounting plate
B. Spring clip
A
B
A
B
9