Installation - VINCENT KHV-200 Manuel D'utilisation

Set up the cable links in a sequence as follows. Connect the power cable between
device and power supply only after all other connections have been made.
Protective caps
Prior to the first installation the protective plastic
caps must be removed from all the connections
used at the rear of the unit.
RCA connections
Mechanically identical RCA plugs are available
for input and output connections. Make sure that
you do not get these connections confused during

installation!

Make sure that you do not mix up the analogue
inputs for right and left. The RCA plugs for these
are mostly colour coded as follows: red for the
right channel, black or white for the left channel.
Speaker cable connections.
Contacting the middle pin of the RCA plugs with
the outer ring of the RCA chassis jack may lead to
damages to the main amplifier if it is switched on!
To avoid this hazard, connect or disconnect only in
switchedoff state and more than one minute after
deactivating!
26
INSTALLATION
DURING INSTALLATION PLEASE OBSERVE
THE FOLLOWING ADVICE:
Kabel und Steckverbindungen
Make sure that all plugs fit tightly. Inadequate
connections can cause noise interference, failures
and malfunctions.
- wrong -
To make the most of the components' sound poten-
tial, only high quality loudspeakers and connecting
cables, for example Vincent cables, should be
used. Your local stockist will be glad to advise you
about this.
SWITCHING THE VOLTAGE
This device is equipped with a switch that can be
used to change the country-specific voltage from
230 V to 110 V. Please never actuate the switch
during operation! The voltage must only be swit-
ched by a technician, since the device fuse must
also be replaced after actuation of the switch! Infor-
mation about the device fuse can be found on the
back of the device.
Unauthorised actuation of the switch will void any
warranty claim!
- correct -