Scheppach OSM600 Traduction Des Instructions D'origine page 30

- Further supplementary take-back conditions of
the manufacturers and distributors can be ob-
tained from the respective customer service.
• If the manufacturer delivers a new electrical appli-
ance to a private household, the manufacturer can
arrange for the free collection of the old electrical
appliance upon request from the end user. Please
contact the manufacturer's customer service for
this.
• These statements only apply to devices installed
and sold in the countries of the European Union
and which are subject to the European Directive
2012/19/EU. In countries outside the European Un-
ion, different regulations may apply to the disposal of
waste electrical and electronic equipment.
16. Troubleshooting
The following table shows fault symptoms and describes remedial measures in the event of your machine failing to
work properly. If you cannot localise and rectify the problem with this, please contact your service workshop.
Problem
Motor doesn't start
Machine gets slower
during work.
Sanding belt comes off
the drive pulleys.
The wood gets burnt
during sanding.
Strong vibrations
30 | GB
Possible cause
ON/OFF switch damaged.
ON/OFF cable damaged
ON/OFF relay damaged
Fuse blown
Motor burnt
Too much pressure put on the
workpiece.
Belt does not run straight.
Sanding disc or belt covered with
grease.
Excessive pressure on work-
piece.
Loosely mounted tool
Defective tool
Spindle knocks
www.scheppach.com
Help
Replace all damaged parts before you use
your machine again.
Contact your local service centre. Every
attempt to carry out a repair, can be dan-
gerous if it is not done by skilled personnel.
Reduce the pressure on the workpiece.
Reset the track.
Replace disc or belt.
Reduce pressure on workpiece.
Tighten tool
Change tool
Repair at a Service-Station