Cleaning And Maintenance; Catalytic Self - Cleaning Oven; Service Centre & Troubleshooting; Protection Of The Environment - Candy CGG 6721 SHX Notice D'emploi Et D'installation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

5. CLEANING AND MAINTENANCE

Before all cleaning and maintenance :
•Cleaning and user maintenance shall not be made by children
without supervision
•Disconnect mains voltage.
•Shut off the gas valve for your own safety. If the oven is adjusted to
natural gas, shut off the natural gas valve.
•If the oven is hot, wait till it has cooled down.
•Clean enamelled surfaces with warm, soapy water or with suitable
brand products. On no account use abrasive powders that may
damage surfaces and ruin the appearance of the cooker.
It is very important to clean the oven each time it is used.
•Use detergents and abrasive metal pads for the stainless steel grills.
•The glass surfaces such as the top, the oven door and the warming
compartment door must be cleaned when they are cold.
•Damage caused by failure to respect this rule is not covered by the
guarantee.
•You can clean burners and burner caps with hot water and detergent.
Also the gas channels of the burners can be cleaned by a brush. Make
sure that burners are dry before replacing them in their seats. Check
correct positioning of the burner.
especially for cakes, pizzas and breads.
•Periodically clean the ignition electrodes of automatic ignition ovens.
This will prevent ignition problems. Check frequently that
the gas channels of burners are not blocked by food residues, etc.
•Wipe the top lid with a dry cloth in order to prevent harmful effects of
water, oil and steam generated by the cooked food.
•Do not use abrasive products, metal cleaning pads, sharp objects,
rough cloths, or chemical products and detergents that can
permanently damage the catalytic lining.
•It is a good idea to use deep roasting trays for fatty foods such as
joints of meat etc. and to put a tray underneath the grill to catch surplus
fat.
Cleaning of Oven Door
For thorough cleaning of the oven door, it is advisable to remove the
same, as shown in below.
Open the door completely, turn the two feet on the hinge arms 180º.
Close the door partly by a 30º. Remove the door by slightly lifting the it
at this position.
For replacing the door, follow the steps above in the reverse order.
To Replace the inside light
•Switch off the mains power supply and unscrew bulb.
Replace with an identical bulb that can withstand very high
temperatures.
0
180
Figure 16
Figure 17

5.1. CATALYTIC SELF - CLEANING OVEN

•Special self-cleaning panels covered in a micro-porous coating are
available on some of our models. If they are fitted, the oven no longer
needs to be cleaned by hand.
•The lining must be porous for self-cleaning to be effective.
•Excessive splattering of fat may block the pores and therefore hinder
self-cleaning. This self-cleaning capacity may be restored by
switching on the empty oven to maximum for about 10-20 minutes.
•If the walls of the oven are so thickly coated in grease that the
catalytic lining is no longer effective, remove surplus grease with a soft
cloth or sponge soaked in hot water. All catalytic linings currently on
the market have a working life about 300 hours. They should therefore
be replaced after about 300 hours.
6. SERVICE CENTRE & TROUBLESHOOTING
•If the oven is not working, before calling the service centre we
recommended that :
•You should check that the oven is properly plugged into the power
supply.
Gas input is abnormal
•Check the following:
•Are the holes of the burner clogged?
•Is the pressure regulator working properly?
•If you are using a pipe, is there any gas in the pipe? Is the valve open?
•If you detect something abnormal with the gas valves, contact a
qualified electrician or an authorised service centre for assistance.
There is a smell of gas where the appliance is placed
•Please check the following:
•Has a gas valve been left open?
•Is the gas pipe in the correct position and in good condition?
If you suspect a gas leak, do not use a flame to check
The oven does not heat up
Are the oven control knobs at the correct position ?
The cooking time is too long
Has the correct temperature been selected ?
Smoke comes from the oven
It is advisable to clean the oven after each use. If fat which splashes
during the cooking of meat is not cleaned, it will cause an unpleasant
smell and smoke the next time you use the oven. (See the Cleaning
and Maintenance chapter)
The oven light does not come on
•The light might be faulty. To change the bulb, please see the relative
page.
•If you have checked the above and the oven still does not work
properly, contact the nearest authorized service for assistance
• Model and Production Number (PNC or ENR).

7. PROTECTION OF THE ENVIRONMENT

•After positioning the appliance, packaging materials
must be correctly disposed of for safety and
environmental purposes.
•Before disposing of old equipment, cut the power
cable in order to render the equipment unusable.
This appliance is marked according to the European
directive 2002/96/EC on Waste Electrical and
Electronic Equipment (WEEE).
•By ensuring this product is disposed of correctly, you will help prevent
potential negative consequences for the environment and human
health, which could otherwise be caused by inappropriate waste
handling of this product.
•The symbol on the product indicates that this product may not be
treated as household waste. Instead it shall be handed over to the
applicable collection point for the recycling of electrical and electronic
equipment
•Disposal must be carried out in accordance with local environmental
regulations for waste disposal.
•For more detailed information about treatment, recovery and
recycling of this product, please contact your local city office, your
household waste disposal service or the shop where you purchased
the product.
15 GB

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Cgm 6724 phxCcg 6102 swCgm 6722 shwCcg 5540 pwCgm 6722 shx

Table des Matières