Use Of Cooktop Burners; Use Of Cooktop Gas Burners - Candy CGG 6721 SHX Notice D'emploi Et D'installation

1- Cook top
2- Control panel
3- Drawer
4- Oven door (Front door)
5- Metallic top lid or Glass top lid
Auxilary burner
6-
7- Rapid burner
8- H ot plate
H ot plate
9-
10- Right grate
11- Burner control knob s s
12- Hot plate control knob s s
13- Thermostat oven knob
14- Ignition button or fan button
15- Signal lamp
1- Cook top
2- Control panel
3- Drawer
4- Oven door (Front door)
5- Metallic top lid or Glass top lid
6- Hot plate
Hot plate
7-
8- Hot plate control knobs
9- Thermostat oven knob
Signal lamp
10-

3. USE OF COOKTOP BURNERS

3.1. USE OF COOKTOP
The knobs which control the burners are positioned on the control
panel.
GAS BURNERS
Figure 7
Off Position
When the knob is turned so that the 'dot' symbol faces towards
the panel, it is in the Off position and the gas valve is closed and
the flame will go out.
Maximum Gas Flow
Press the burner knob and turn it to the left till the 'dot' symbol
faces towards the large flame symbol.
The flame is on full at this position.
In this position, the gas valve is completely open.
Minimum Gas Flow
The flame can be decreased by turning the knob so that the 'dot'
symbol faces towards the small flame symbol. The valve will be
partially open and the burner will then be on low.
F
Ignition of the Burners
Cooktop Gas Burners
The burner must be ignited before a pan is placed over it.
For models with automatic ignition, the 'spark' button must be
pressed.
Press the knob controlling the burner you want to ignite and then turn it
left to the big flame symbol. Press the ignition button. On models with
ignition-thru knobs, press and turn the knob controlling the burner you
want to ignite as far as the star symbol; the electrode will be
automatically activated. All the electrodes will be activated
automatically and the burner to which gas is supplied (that relative to
the knob pressed) will ignite.
Oven Gas Burners
The button must not be kept pressed down for more than 15 sec. If the
burner has not ignited after 15 sec. release the button and open the
compartment door and/or wait at least 1min. before attempting again.
For other models the gas is ignited by means of the control knobs.
Make sure that the gas is actually burning after this
step! If there is no flame, repeat the procedure
10 GB
A - Burner Lid
B
- Burner
C
A - Electrode
D
- Injector ( Jet )
E - Burner body
F - Safety device
B
C
D
E
Figure 8