Festo DGEA YSR Série Notice D'utilisation page 11

DGEA−...−YSR
3. Fasten the shock absorber in the hole of
the shock absorber support with the aid
of the two locking nuts. At the same time
make sure that dimension s on the con
tracted shock absorber is observed.
DGEA−...
18
25
40
4. Place the sliding blocks in the groove on
the side of the cantilever arm. By means
of a recess, sliding blocks which cannot
be clipped in by tilting, slide into the rel
evant groove.
5. Place the DGEA−...−YSR over the sliding
blocks at the same time observing mini
mum dimension L.
DGEA−...
18
25
40
6. Fasten the shock absorber support
together with the shock absorber with
contact to the drive head.
Festo DGEA−...−YSR 0707a English
YSR−... S [mm]
...−16−20−C 2
...−20−25−C 2
...−25−40−C 2
L [mm]
67
60
81
Fig. 3
Fig. 4
11