Technical Data - Earlex Spraystation Motor Spray 3000 Mode D'emploi

MotorSpray3000
Problem
Atomisation too
coarse
Spray jet pulsates
Coating material
causes "paint tears"
Too much fog of
coating material
(Overspray)

21. Technical Data

Max. viscosity:
Power source:
Power consumption:
Atomizing output:
Max. flow rate:
Double insulation:
Sound pressure level*:
Sound pressure output*:
Oscillation level*:
Air hose length:
Weight:
* Measured in accordance with EN 60745-1
Cause
•
Material volume too large
Material volume setting
turned too far to the left (+)
•
Nozzle contaminated
•
Viscosity of coating material
too high
•
Too little pressure build-up
in container
•
Air filter heavily soiled
•
Coating material in container
running out
•
Nozzle seal worn
•
Air filter heavily soiled
•
Too much coating material
applied
•
Viscosity of coating material
too low
•
Distance to the object too
large
•
Too much coating material
applied
•
Material very thin
Technical Data
170 DIN-s
230 V ~ , 50 Hz / 240 V ~ , 50 Hz
640 W
200 W
200 ml/min
79 dB (A); Uncertainty K = 4 dB
92 dB (A); Uncertainty K =4 dB
< 2.5 m/s²; Uncertainty K = 1.5 m/s²
12 m
approx. 3.7 kg
Remedy
➞ Turn material volume
adjusting screw to the
right (-)
➞ Clean
➞ Dilute further
➞ Tighten container
➞ Change
➞ Refill
➞ Replace
➞ Change
➞ Turn material volume
adjusting screw to the right (-)
➞ Reduce distance
➞ Turn material volume
adjusting screw to the right (-)
➞ Dilute less
/ 660 W
EN
25