Coating Materials Not Suitable For Use; Preparation Of The Coating Material; Start-Up - Earlex Spraystation Motor Spray 3000 Mode D'emploi

EN

7. Coating Materials Not Suitable for Use

Materials that contain highly abrasive components, facade paint, caustic solutions and
acidic coating substances.

8. Preparation of the Coating Material

Please ensure that the processing instructions of the manufacturer of the
i
material are observed.
The spray device can be used to spray undiluted or slightly diluted materials. Detailed
information is available in the technical data sheet of the manufacturer ( Internet
Download).
1. Stir the material and put the required amount into the paint container.
Sprayed material
Spray film, paints containing solvents and water-soluble
paints, primers, vehicle coating paints, thick-film glazes
2. If the convey capacity is too low, add 5 - 10 % dilution step-by-step until the convey
capacity fulfils your requirements.

9. Start-up

Before connecting to the mains supply, be sure that the supply voltage is identical with
the value given on the rating plate.
•
Unscrew the container from the spray gun.
•
Aligning suction tube. (Fig. 2)
If the suction tube is positioned correctly, the container contents can be sprayed
without almost any residue.
When spraying horizontal surfaces, turn suction tube forward. (Fig. 2 A)
When spraying objects overhead, turn suction tube back. (Fig. 2 B)
•
Set the container on a sheet of paper, pour in the prepared coating material and
screw the container tightly onto the spray gun.
•
Mount the air hose (Fig. 3, a + b). Insert the air hose firmly into the connection of the
unit and the gun handle. The position of the hose is not relevant.
•
Set up the spray device at least 5 metres outside of the hazard zone.
•
Put the machine down only on a level, clean surface. Otherwise, the gun may suck in
dust, etc.
•
Push the ON/OFF switch at the device.
•
It is advisable to test spray cardboard or a similar material in order to determine the
material quantity and the spray pattern.
20
Thinning recommendation
MotorSpray3000
dilute by 0 - 10 %