- EN -
Scope of delivery
A
Quantity
1
1
2
3
3
1
4
1
5
1
6
1
7
1
8
1
Intended use
PondoSolar 600 Control, referred to as "unit", may only be used as specified in the following:
• For creating a water fountain in a pond.
• For operation with clean water.
• Operate in accordance with instructions.
The following restrictions apply to the unit:
• Never use the unit to convey fluids other than water.
• Never run the unit without water.
• Do not use in conjunction with chemicals, foodstuff, easily flammable or explosive substances.
Installation and connection
How to proceed:
B
Assemble the nozzle unit and the LED lighting and fit onto the pump.
– Adapt the number of nozzle extensions used to the depth of the pond.
Connect the connection cables of the pump and LED lighting to the solar module. (→ Commissioning/start-up)
– Push each plug into the socket as far as possible to ensure that the connection is watertight.
Assemble the ground stake set and attach it to the solar module.
– Align the solar module such that the sockets with the connection cables point downwards.
Install the solar module so that it is exposed to direct sunlight.
– Recommendation: Align the solar module to the sun to ensure maximum energy yield.
Install the unit in the pond in a horizontal position on firm, sludge-free ground and ensure that it is completely covered
with water.
10
Description
Pump with 5 m connection cable
Nozzle extension
Nozzle
Nozzle holder with nozzle attachment
Solar module
Ground stake set
Remote control
LED lighting with 5 m connection cable