Changing The Setpoint Temperature; Locking/Unlocking The Digital Temperature Controller; Maintenance; General - Hatco CDW-3N Série Manuel D'installation

English

Changing the Setpoint Temperature

Use the following procedure to change the setpoint temperature
of the unit.
1. Press and release the
temperature will be shown on the display and "out 1" will
flash in the upper left corner.
2. Press the key or
change the setpoint temperature. If no key is pressed
within 15 seconds, the display will revert to the current
temperature of the unit.
3. Press the key or wait 15 seconds to lock in the new
setpoint temperature.

General

The Hatco Convected Drawer Warmer is designed for maximum
durability and performance with minimum maintenance.
WARNING
ELECTRIC SHOCK HAZARD:
• Turn OFF power switch, unplug power cord, and
allow unit to cool before performing any cleaning,
adjustments, or maintenance.
• DO NOT submerge or saturate with water. Unit is not
waterproof. Do not operate if unit has been submerged
or saturated with water.
• Do not steam clean or use excessive water on the unit.
• This unit is not "jet-proof" construction. Do not use
jet-clean spray to clean this unit.
This unit must be serviced by qualified personnel only.
Service by unqualified personnel may lead to electric
shock or burn.
This unit has no "user-serviceable" parts. If service
is required on this unit, contact an Authorized Hatco
Service Agent or contact the Hatco Service Department at
800-558-0607 or 414-671-6350.
Form No. CDWM-0418
key. The current setpoint
key within 15 seconds to
Locking/Unlocking the Digital Temperature
Controller
The keys on the digital temperature controller can be locked to
prevent unauthorized changes to the settings.
To lock the keys of the digital temperature controller:
• Press and hold both the
same time for over two seconds. The message "Loc" will
appear on the display.
To unlock the keys of the digital temperature controller:
• Press and hold both the
same time until the message "UnL" appears on the display.

Daily Cleaning

To preserve the finish of the unit as well as maintain
performance, it is recommended that the unit be cleaned daily.
1. Turn off the unit, unplug the power cord, and allow the unit
to cool.
2. Remove and wash all food pans.
3. Wipe down all stainless steel surfaces using a damp
cloth. Stubborn stains may be removed with a good non-
abrasive cleaner. Hard to reach areas should be cleaned
with a small brush and mild soap.
Use non-abrasive cleaners and cloths only. Abrasive
cleaners and cloths could scratch finish of unit, marring its
appearance and making it susceptible to soil accumulation.
4. Wipe dry the entire unit using a dry, non-abrasive cloth.
7
OPERATION
key and
key and

MAINTENANCE

NOTICE
key at the
key at the