Electrical Rating Chart; Dimensions; Installation; General - Hatco CDW-3N Série Manuel D'installation

English

Electrical Rating Chart

Model Voltage
CDW-3N 120
230
CDW-3N2 120
230

Dimensions

Width
Model (A)
16-5/8 "
CDW-3N
( 420 mm)
CDW-3N2 16-5/8 "
( 420 mm)

General

The Convected Drawer Warmer is shipped with most
components pre-assembled. Casters must be installed on
location. Care should be taken when unpacking the shipping
carton to avoid damage to unit and the components enclosed.
WARNING
ELECTRIC SHOCK HAZARD: Unit is not weatherproof.
Locate the unit indoors where the ambient air temperature
is a minimum of 70°F (21°C).
FIRE HAZARD: Locate unit a minimum of 1" (25 mm) from
combustible walls and materials. If safe distances are not
maintained, discoloration or combustion could occur.
NOTE: The unit must be transported in the upright position.
Form No. CDWM-0418
Watts Amps
1015 8.5
933 4.1
1015 8.5
933 4.1
Depth Height
(B) (C)
30-1/2 " 30 "
( 762 mm)
(774 mm)
30-1/2 " 30 "
( 762 mm)
(774 mm)
Plug Configuration
NEMA 5-15P
CEE 7/7 Schuko, AS 3112, BS-1363
NEMA 5-15P
CEE 7/7 Schuko, AS 3112, BS-1363
A
C
Front View
1. Remove the unit from the carton.
NOTE: To prevent delay in obtaining warranty coverage,
complete online warranty registration. See the
IMPORTANT OWNER INFORMATION section for
details.
2. Remove tape and protective packaging from all surfaces
of the unit
3. Install the casters onto the unit. Refer to the installation
procedure in this section.
4. Place the unit in the desired location.
• Locate the unit in an area where the ambient air
temperature is constant and a minimum of 70°F
(21°C). Avoid areas that may be subject to active air
movements or currents (i.e., near exhaust fans/hoods,
air conditioning ducts, and exterior doors).
• Make sure the unit is located on solid, level flooring.
• Make sure the unit is at the proper height in an area
convenient for use.
5
SPECIFICATIONS
Shipping Weight
179 lbs. (81 kg)
179 lbs. (81 kg)
179 lbs. (81 kg)
179 lbs. (81 kg)
B
Side View

INSTALLATION