Installing Casters; Operation; General - Hatco CDW-3N Série Manuel D'installation

INSTALLATION

Installing Casters

Use the following procedure to install casters onto the bottom
of the unit.
NOTICE
Do not lay unit on the front or back side or damage to the
unit could occur.
1. Remove any pans from the drawers of the unit.
2. Carefully lay the unit on its left or right side (requires two
people).
3. Align the four holes on the caster plate with the four holes
in the unit mounting bracket at one corner of the unit
4. Install a bolt through each of the holes in the caster plate
and into the unit mounting bracket. Tighten securely.

OPERATION

General

Use the following procedures to operate a Convected Drawer
Warmer.
WARNING
Read all safety messages in the IMPORTANT SAFETY
INFORMATION section before operating this equipment.
1. Plug the unit into an electrical receptacle of the
correct voltage, size, and plug configuration. See the
SPECIFICATIONS section for details.
2. Move the POWER ON/OFF (I/O) switch to the ON (I)
position. The switch will illuminate.
• The digital temperature controller will energize and
the current temperature of the unit will appear on the
display.
• The phrase "out 1" will appear in the upper left corner of
the display to show that the unit is in heat mode.
BURN HAZARD:
• Some exterior surfaces on unit will get hot. Use caution
when touching these areas.
• Use caution when opening drawer. Hot air escapes
when drawer is open.
CAUTION
Digital Temperature Controller
Caster Plate
Bolt
5. Repeat steps 3 and 4 for the remaining three casters.
6. Return the unit to the upright position (requires two
people).
3. Press and release the
controller to verify the setpoint temperature.
• The setpoint temperature will be shown for 15
seconds. After 15 seconds, the display will revert
to the current temperature of the unit. To change the
setpoint temperature, refer to "Changing the Setpoint
Temperature" in this section.
"out 1"
SET
Key
NOTE: The digital temperature controller is pre-set to a setpoint
temperature of 195°F (91°C) at the factory. Once the
setpoint temperature is changed, the new setpoint
temperature will remain in memory until it is changed
again. The maximum setpoint temperature is 195°F
(91°C).
4. Allow the unit 15–20 minutes to reach operating
temperature before loading preheated food product.
POWER ON/OFF (I/O) Switch
CDW-3N Control Panel
6
Mounting
Bracket
Installing Casters
key on the digital temperature
Down Arrow
Up Arrow
Key
Key
Digital Temperature Controller
Form No. CDWM-0418
English
Fahrenheit
Symbol