Changing The Temperature Settings; Changing Between Celsius And Fahrenheit; Updating The Firmware - Hatco HDW-R2 Série Manuel D'installation Et D'utilisation

Tiroirs chauffants séparés
Masquer les pouces Voir aussi pour HDW-R2 Série:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

English

Changing the Temperature Settings

Use the following procedure to set or change the air temperature
of the unit. The touchscreen controller is pre-set at the factory
to an air temperature of 180°F (82°C).
1. Move the Power I/O (on/off) switch to the I (on) position.
• The unit will turn on and the touchscreen controller will
energize and show the Home Screen.
2. Touch the desired temperature
setting to adjust.
3. Touch the red
or
the display to set the desired air
temperature.
NOTE: Air
temperature
depending upon product make-up
and consistency.
4. Touch the
key to save the
settings and return to the Home
Screen.

Changing Between Celsius and Fahrenheit

Use the following procedure to change the air temperature unit
of measure between Celsius and Fahrenheit.
1. Move the Power I/O (on/off) switch to the I (on) position.
• The unit will turn on and the touchscreen controller will
energize and show the Home Screen.
2. Touch the
key.
• Enter the password [2 4 8] using
the number keys that appear.
• The Service screen will appear on
the display.
3. Touch the CONTROL key on the
Service screen to access the
Control Settings screen.
4. Choose the desired unit of measure
on the "Units" line:
• Touch the "F" box to select
Fahrenheit.
• Touch the "C" box to select
Celsius.
NOTE: The box for the active unit of
measure is highlighted in green.
5. Touch the
key to save the
settings and return to the Home
Screen.
Form No. HDWR2M-0518
key on
may
vary
OPTIONS AND ACCESSORIES

Updating the Firmware

Use the following procedure to perform a firmware update on
the touchscreen controller.
1. Move the Power I/O (on/off) switch to the I (on) position.
• The unit will turn on and the touchscreen controller will
energize and show the Home Screen.
2. Touch the
key.
• Enter the password [2 4 8] using the number keys that
appear.
• The Service screen will appear on the display.
3. Touch the firmware key on the Service screen to access
the Firmware Update screen.
4. Insert the USB drive into the USB
port next to the controller, and touch
the update key on the Firmware
Update screen.
• The update will begin. When
complete,
the
controller will restart and show
the Home Screen.
11
touchscreen

Publicité

Chapitres

Table des Matières
loading

Ce manuel est également adapté pour:

Hdw-1r2Hdw-1.5r2Hdw-2r2

Table des Matières