Installation; General; Installing Hdm-2 Models - Hatco DRAWERMAX HDM Série Manuel D'installation Et D'utilisation

INSTALLATION

General

DRAWERMAX™ Drawer Warmers are shipped with most
components pre-assembled. Care should be taken when
unpacking the shipping carton to avoid damage to the unit and
components enclosed.
WARNING
ELECTRIC SHOCk HAzARD: Unit is not weatherproof.
Locate the unit indoors where the ambient air temperature
is a minimum of 21°C (70°F).
FIRE HAzARD: Locate the unit a minimum of 25 mm (1")
from combustible walls and materials. If safe distances are
not maintained, combustion or discoloration could occur.
NOTICE
Do not lay unit on the front or back side. Damage to the
unit could occur.
1. Remove the unit from the carton.
2. Remove the information packet from the drawer of the unit.
NOTE: To prevent delay in obtaining warranty coverage,
complete online warranty registration. See the
IMPORTANT OWNER INFORMATION section for
details.
3. Remove tape and protective packaging from all surfaces of
unit.
4. Make sure the desired installation location is appropriate.
• Locate the unit in an area where the ambient air
temperature is constant and a minimum of 21°C (70°F).
Avoid areas that may be subject to active air movements
or currents (i.e., near exhaust fans/hoods and air
conditioning ducts).
• Make sure the unit is located on solid, level flooring or
in sturdy cabinetry.
• Make sure the unit is at the proper height in an area
convenient for use.
5. Install the unit. Refer to the appropriate installation
procedure in this section.

Installing HDM-2 Models

HDM-2 models are freestanding units that require the
installation of 102 mm (4") legs before operation.
1. Remove the plastic bag containing the four legs from the
drawer of the unit.
2. Remove any pans from the drawers and carefully lay the
unit on its side (requires two people).
3. Install each leg. Hand-tighten the legs until snug. Do not
over-tighten.
4. Return the unit to its upright position (requires two people).
If the unit is not level or rocks, turn the adjustable tip of the
appropriate leg to level the unit.
Figure 7. Leg Assembly
6
Shorten
Lengthen
Adjustable Tip
102 mm (4") Leg
Form No. HDMCEM-1010