Programming The Stick Positions - Multiplex ROXXY BL-Control 900 Série Notice D'utilisation

3. Specifi cation
Load current
Peak load
Dimensions (mm)
Weight (g)
Cell number
BEC
SPS
Rx-Filter
PCO
POR
hec
TP
Cool Power FET

4. Programming the stick positions

!
If you wish to change the model type (Parameter 4 or Parameter 5), please note that this parameter must be set before you
change the other parameters.
Forward, stop and reverse
1. Connect the speed controller as shown in the wiring diagram (but don't connect the drive battery).
2. Switch the transmitter on, and move the throttle stick to the "forward" position.
3. Connect the drive battery to the speed controller.
If the LED lights up after point 2, you must reverse the throttle channel using the transmitter's SERVO REVERSE facility.
!
Disconnect the drive battery from the speed controller, then start again at point 1. The "forward" position of the throttle stick
most be at or close to its mechanical end-stop.
4. The controller emits a brief series of beeps to confirm connection.
5. After about ten seconds a double series of beeps confirms that it has detected the "stick forward" position.
6. Move the throttle stick to the "stop" position. A brief series of beeps confirms that the controller has detected the "stop" position.
7. Move the throttle stick to the "reverse" position; a triple
series of beeps confirms that the controller has detected
the "reverse" position.
12
BL 940-6 BL 950-6
Nr. 31 8631 Nr. 31 8632
40 A
50 A
66 x 25 x 10 66 x 25 x 10
47 g
6...18 NC/NiMh 6...18 NC/NiMh
2...6 LiPo 2...6 LiPo
5,5 Volt 5,5 Volt
max. 3 A/kurz. 5 A max. 3 A/kurz 5 A
32 kHz 32 kHz
BL 960-6
Nr. 31 8634
50 A 60 A
60 A 70 A
66 x 25 x 10
49 g 49 g
6...18 NC/NiMh
2...6 LiPo
5,5 Volt
max. 3 A/kurz. 5 A
32 kHz
Forward and stop (Model type Air/Heli)
The throttle stick positions "forward" and "stop" for
!
"forward only" controllers are programmed in the same
manner as far as point 6. The procedure is confi rmed
with a triple series of beeps.
BL 9100-6
Nr. 31 8635
100 A
110 A
76 x 26 x 13
67 g
6...18 NC/NiMh
2...6 LiPo
5,5 Volt
max. 3 A/kurz. 5 A
32 kHz